New Systems · Raleigh, NC
System replacement and installation
When a system is genuinely at the end, we size a new one for your house and put it in. When it isn't, we tell you that instead.
When it’s time
A failed compressor on an old unit. A cracked heat exchanger. A refrigerant leak in a coil for a system that uses refrigerant nobody stocks anymore. Repair bills that keep coming back on the same unit. Those are the honest reasons to replace. A bad capacitor is not one of them.
What the job involves
- Measure the house, check the ductwork and size the equipment. Bigger is not better; an oversized unit short-cycles and leaves the house clammy.
- Go over the options: heat pump, gas furnace with AC, or a straight swap of what you have.
- Pull the old equipment, set the new outdoor unit and indoor coil or air handler, run and braze the line set.
- Pull a vacuum, charge the system, wire the thermostat, test in both heating and cooling.
- Walk you through the new thermostat and the filter before we leave.
Why call Bluepine
Read Tyrell’s review on the right. He called about a unit he figured was dead and left with a capacitor. That’s how we approach every repair call, so when we do say a system is finished, it’s because it is.
Think the unit is done?
Call. We'll come look before anyone talks about a new one.